Hi there: I use a hybrid 416/516 system: 516 on right hand (velcro base, but will be making use of the stickys soon), 416 on the left, mounted from underneath.
The 516 cable entry is pretty reasonable and well supported, but the 416 cable entry is not strain relieved, so inevitably I got a knee in the wrong place and pulled it half off. Soldering Iron (to fix) + Heatshrink to provide a strain relief at the point the cable enters the mic gooseneck seems to have done the job - if the heatshrink is large enough to clip into the cable guides on the 416 base mount, so much the better.
The reason I don't use 516's both ends is: I find the softer gooseneck coupled with the heavier capsule "walks" the mic away from the instrument as I play.....!
I've found a slight spike at about 5kHz with them when using the two-mic pattery pack though, but they are the most feedback-immune mics I know of. I don't have the mic inside the bass end of the box because I don't like the sound it gives (I've experimented with Tandy, Microvox, assorted component electrets etc etc).
(p.s. couple them with an Behringer Ultragain front end MIC2200, and suddenly 5kHz spike vanishes + there's a distinct increase in "crispness"... just found that out by accident...)
2p duely deposited,