Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Hohner Corona II bass buttons  (Read 1341 times)

0 Members and 1 Guest are viewing this topic.

Neil_M

  • Good talker
  • **
  • Offline Offline
  • Posts: 73
Hohner Corona II bass buttons
« on: March 29, 2011, 01:43:45 PM »

I've just got hold of a Corona II in G/C/F in order to have a crack at some French tunes without sending the dog loopy - bit high pitched on the Pokerwork! I like the sound of the Corona but have an issue with the bass buttons in that they're pretty much flush with the casing at it's highest point. I guess this is much the same as an Erica??

Having to press the buttons into the hole is a bit awkward, perhaps it's a combination of chunky fingers and being used to the Pokerwork. I had a peek inside to see if the bass mechanism could be lifted a fraction but I'd only achieve about 1mm doing this before the pallets stopped covering their corresponding holes properly.

Thought I'd ask if there's any solution out there to raising the buttons? Are the actual buttons themselves glued on to the push rod - is there any room for manoeuvre here?

Any advice appreciated  (:)
Logged
Pressed Wood G/C

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Hohner Corona II bass buttons
« Reply #1 on: March 29, 2011, 02:41:54 PM »

Thought I'd ask if there's any solution out there to raising the buttons?

Just bend the levers, the ones at right angles to the base board, they bend fairly easily, certainly enough to get the buttons a couple of mm higher.   Don't raise then too height though,  you only need a total travel of 3 to 4 mm.  On a Corona or Erica with a normal setup its quite possible to do this by pushing the buttons till they are flush with the casing.  Too long a travel can also make playing more difficult.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Neil_M

  • Good talker
  • **
  • Offline Offline
  • Posts: 73
Re: Hohner Corona II bass buttons
« Reply #2 on: March 29, 2011, 11:28:23 PM »

Thanks Theo - I've done as you suggested and it works well. Only problem I had was a couple of the pallets weren't sitting quite flat after bending the lever, a bit of tweaking soon sorted that out thankfully!

Instantly more playable  :D
Logged
Pressed Wood G/C
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal