Also, if the reeds are 20 cent apart, as mentioned earlier, what would that represent in terms of a 440 number? Again, I know I'm not really making sense here but I hope you can decipher what I'm trying to get at
The answer is that the relationship between cents offset and the frequency difference in Hertz (your '440 number') is not linear, but logarithmic across the range of notes. If you wanted a constant tremolo rate of, say 4 beats per second (a moderately wet sound) across the range, you need a larger cents offset for the lower notes than you do for the upper notes. This is because the cents offset and the frequency difference (which controls the tremolo rate) vary according to the following formula:
c = 1200 × log2 (f2 / f1)where c = the cents difference between the two reeds and
f2 &
f1 are the frequencies of the two reeds in Hz.
If you are confident in using Excel spreadsheets it is not hard to generate a listing of the cents offset required to give any required tremolo rate across the range, but for now, just to illustrate the effects of that logarithmic formula, here are some examples of the cents offset required to give a constant tremolo rate of 4 beats per second for the note A in different octaves:
A2 (110 Hz) Cents offset: 61.8
A3 (220 Hz) Cents offset: 31.2
A4 (440 Hz) Cents offset: 15.7
A5 (880 Hz) Cents offset: 7.9
A6 (1760 Hz) Cents offset: 3.9
This listing assumes one reed is tuned to the note 'at pitch' and the second reed is tuned sharp. You can see how the offset required decreases as the pitch of the note gets higher.
If you were discussing your tuning requirements with a competent tuner, it would normally be sufficient to state the tremolo rate required at A = 440 Hz, and then leave it up to their expertise to apply that across the range of the instrument.
Whether or not you wanted a constant tremolo rate across the whole range is a different matter again and depends on the personal preferences of the player. As far as I am aware, based on my somewhat limited experience of tuning, most instruments have a slower tremolo rate for the lower notes and a somewhat faster tremolo rate for the higher notes, with a relatively smooth transition across the range (known as 'tuning on the curve' I believe). It just sounds better when done that way. But other people here may have their own ideas and preferences.