Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: stuck key (button) on a pokerwork  (Read 1568 times)

0 Members and 1 Guest are viewing this topic.

stevejay

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 709
stuck key (button) on a pokerwork
« on: September 22, 2011, 08:43:56 PM »

I'm going to open it up and see soon, but any caveats or words of advice? All was fine but now a button sticks after being depressed.

Thanks,

Steve

PS treble side
« Last Edit: September 22, 2011, 08:45:41 PM by stevejay »
Logged

Lester

  • MADman
  • Mods and volunteers
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 9327
  • Hohners'R'me
    • Lester's Melodeon Emporium and Tune-a-Rama
Re: stuck key (button) on a pokerwork
« Reply #1 on: September 22, 2011, 08:50:41 PM »

If it's depressed it probably just needs counselling  ;D

But more sensibly, just remove the grille and you can see just about all the treble mechanism and should be able to diagnose the problem.

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: stuck key (button) on a pokerwork
« Reply #2 on: September 22, 2011, 09:18:56 PM »

Sometimes a button can move to the side and catch under the edge of the hole in the fingerboard. If it dies not spring up when tweaked back, then the spring may be broken.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

Christopher K.

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 894
Re: stuck key (button) on a pokerwork
« Reply #3 on: September 22, 2011, 09:19:53 PM »

The lever inside the keyboard cover might not be properly aligned with the hole where the button protrudes, so that the button sticks under the edge of the hole when it is depressed. Take off the grille and with a pair of needlenose pliers, give the lever arm a tweak to one side or the other to line it up correctly. It should go in and out of the hole in the keyboard cover without contacting the sides.

stevejay

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 709
Re: stuck key (button) on a pokerwork
« Reply #4 on: September 22, 2011, 09:30:49 PM »

Thanks for all these quick replies! I will keep them in mind while I inspect.  Believe it is a lever issue at this point.
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal