A few months back I acquired an old Supertone box. I am guessing it dates to the 1920's. There has been some interest in these on the forum as seen in
this thread. I am finally able to proceed on the project. Mine is a 2 row, 16 bass wood bodied instrument in Bb/Eb. Here are some
photos.
I found it necessary to remove and clean all of the reeds, as there must have been an instance where the wax (or resin from the wax) got on the reed plates and tongues. I also had to plane down the bases of reedblocks a trifle, there was a small amount of warp in them. The reeds have rectangular, rather than tapered tongues, and are set on zinc plates marked with an O. Having installed new valves and tuned the reeds, I was pleasantly surprised by the result. I chose a rather dry tuning, and the end result is much to my liking. The basses have a full rounded sound, and the instrument has a strong voice.
Compression is pretty good, considering that it has original pallets and end gaskets. I have improved it marginally by carefully adjusting the pallet-to-(unknown board) seal. The drawbacks on this box are the treble and bass button mechanisms, which are fashioned out of wood, with wood pivots, operating bits of thin rod holding the pallets. They are a bit heavy to operate, and are not nearly as smooth as the metal equivalents. That being said, one learns to cope with this setup, after all, it's an oldie. This type of box is a great cross-trainer, even though it takes a bit more effort and air to play it, the sound and feel is worth it. And when you pick up your newer, slicker box, it suddenly feels like you're driving a Ferrari!.
No one is quite sure what company produced the Supertone, but it does have many similarities to Hohner-made boxes. This can be seen in the corner hardware, and some of these sport the long wooden bar on the bass end that serves as an air button. I have one of these on my old wooden Hohner three-row, and it's a fine air button...er...bar! Unfortunately, my Supertone has what must be a transitional piece, a rather sorry little brass lever. All in all, I really like this box, it has a sturdy, solid quality to it, not quite as refined as the Hohners, but very close. Also, the case is made of solid wood (probably maple or poplar) with a lovely veneer of perhaps light walnut, and also has edging and details of marquetry, unlike the faux woodgrain that is so common from that era. Not to mention a solid voice! I would recommend these to anyone wishing to take on a restoration, if you come across a good one.
As can be seen in my photos, it is a bit taller and wider than a Pokerwork, bit about the same depth. I have included a
video so you can hear it, although my tuning is not yet complete. Makes all the same clacking noises as a genuine Hohner!