Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Stradella Salas project  (Read 1130 times)

0 Members and 1 Guest are viewing this topic.

johnm3487

  • johnm3487
  • Member
  • *
  • Offline Offline
  • Posts: 8
Stradella Salas project
« on: November 15, 2011, 12:18:40 AM »

Hi everyone, haven't done much of this posting malarkey since I joined the group as any information I have needed in the past I have found in previous posts, but I could do with some input on my current melodeon/accordion challenge.
I have acquired a Stradella Salas 3 row/stradella base. Actually I just removed it from the childhood home loft (with permission)
To my untrained eye initial inspection showed that I am missing the treble finger board, some of the celluloid is tatty/brittle and a good clean was required oh and new valves and probably some tuning will be required as well as some new bellow corners, thankfully bellows themselves in good condition.

I have just removed/cleaned the treble keys, levers and pallets found that the sound board/Fondo (pallets rest on top)  has a crack on the 1st layer of wood on the pallet side.
My current thinking regarding a repair is that  after gluing, filling, sanding flat the cracked area I can strengthen the area by putting another veneer/aeroplane ply layer on top. There appears to be enough room to accommodate this type of repair/bodge or I can go the full hog and construct a knew sound board from aeroplane ply (brass stops sandwiched between 2 layers of ply)although I am sure there will be a lot more to it than that brief statement but I will cross that bridge when and if I take this route to the repair.

To help me make a decision can anyone shed some light on how the sound board is actually installed i.e. glued only to the outer casing and supports at rear (supports are around casing in reed block side of sound board) or rebated into the casing and/or nailed through the casing.
As far as I can see it may be just glued in place and therefore reasonably easy to remove (dampen with water), but I don't want to rush in and find that I have bitten of more than I can chew as all I am looking for at the moment is basically to gain some experience on the internal workings/repairs and eventually a playable second box (current squeeze is Gaelic iv).

I would also like to take this opportunity say big thank you to administrators/contributors for  the commitment/time involved in keeping melodeon net informative and running smoothly.

I will try and post pictures of damaged area in the next couple of days. Hopefully I have attached one of the box.

I am off to bed

Cheers
John


Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal