Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Best Way to Release Reed Blocks on a Gaillard  (Read 1278 times)

0 Members and 1 Guest are viewing this topic.

docEdock

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 390
  • Hohners, Gaillards, Castagnaris
    • LoafingAboard
Best Way to Release Reed Blocks on a Gaillard
« on: November 19, 2011, 12:35:15 PM »

My -- new to me -- Gaillard's method for securing the reed blocks uses three screws: two on the reed block and one into the body. Is there a preferred method for releasing the pressure, like say loosening the two screws that secure the slider but not turning the third screw? If so, is it best to loosen the inner (closest to the middle of the reed block) or outer screw first?
Logged
How difficult can it be?
http://loafingaboard.blogspot.com/

Lester

  • MADman
  • Mods and volunteers
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 9327
  • Hohners'R'me
    • Lester's Melodeon Emporium and Tune-a-Rama
Re: Best Way to Release Reed Blocks on a Gaillard
« Reply #1 on: November 19, 2011, 12:47:18 PM »

My Tommy had the same fixings, I always slackened off the non-block screws first then the ones on the block sufficiently to be able to slde the clamp thus releasing the block. This seemed the most sensible way to me but can't work out why  ??? But it was successful.

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Best Way to Release Reed Blocks on a Gaillard
« Reply #2 on: November 19, 2011, 02:49:36 PM »

You should not disturb the single screw, just the two that go into the block itself, then you don't disturb the tightness of the block when it is re-fitted.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

docEdock

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 390
  • Hohners, Gaillards, Castagnaris
    • LoafingAboard
Re: Best Way to Release Reed Blocks on a Gaillard
« Reply #3 on: November 19, 2011, 05:41:02 PM »

You should not disturb the single screw, just the two that go into the block itself, then you don't disturb the tightness of the block when it is re-fitted.

Thanks, makes sense.

My Tommy had the same fixings, I always slackened off the non-block screws first then the ones on the block sufficiently to be able to slde the clamp thus releasing the block. This seemed the most sensible way to me but can't work out why  ??? But it was successful.

Lester, I used that same approach and then wondered.
Doc
Logged
How difficult can it be?
http://loafingaboard.blogspot.com/
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal