Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: 1 [2]   Go Down

Author Topic: Broken Spring  (Read 5521 times)

0 Members and 1 Guest are viewing this topic.

Lester

  • MADman
  • Mods and volunteers
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 9327
  • Hohners'R'me
    • Lester's Melodeon Emporium and Tune-a-Rama
Re: Broken Spring
« Reply #20 on: August 24, 2016, 12:39:22 PM »

Thank you for all the information.

With the help of a good plier first, and then a drill chuck well tight, I could remove the axle very easily, and so it was easy to remove the broken Spring and replace with a new one. So the treble mechanism is now ready for playing.

But then I had this problem: it is very hard to screw the treble mechanism in it's place (4 screws), because the mechanism is far from the screw holes. Do you think I need to unhook the springs to do this? (because I already hooked the springs with the loose treble mechanism...)

Where possible you should always unspring the mech before refitting

Pequod

  • Member
  • *
  • Offline Offline
  • Posts: 29
Re: Broken Spring
« Reply #21 on: August 24, 2016, 02:10:01 PM »

Ok, I will try that way. I'm a bit cautious because I imagine it will be hard to hook the springs with the treble mechanism screwed, because of the few space available to do it properly. But I think I don't have a choice here. Thank you.
Logged

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Broken Spring
« Reply #22 on: August 24, 2016, 02:24:28 PM »

It is usually possible, if the springs have poor access, to push the keyboard carefull into place, then put in the screws.  You might be able to devise a way to clamp the keyboard into position, or get an assistant to help.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

squeezy

  • Quick starter (now lagging behind)
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 1317
  • Hohner Cornelia (mixte D/G/o&s)
    • www.johnspiers.co.uk
Re: Broken Spring
« Reply #23 on: August 24, 2016, 04:13:57 PM »

It is usually possible, if the springs have poor access, to push the keyboard carefull into place, then put in the screws.  You might be able to devise a way to clamp the keyboard into position, or get an assistant to help.

I'm very wary of doing this as I managed to really mess things up the first couple of times I replaced springs on my pokerwork.  The problem with leaving the spring tension there before screwing the tiny screws back in to the fondo, there's a high chance that the screws will rip out of the wood if it springs back ... and once that has happened it can be very hard to get the screws to stay in!  I ended up having to use some tiny long nuts and bolts to solve my mistake.

It is difficult to get the springs back in place after reassembly, but I've found the ideal tool in a very small crochet hook that can easily hold the spring without it slipping.
Logged
Squeezy

Sometimes wrong, sometimes right ... but always certain!

Henry Piper

  • Respected Sage
  • ****
  • Offline Offline
  • Posts: 368
Re: Broken Spring
« Reply #24 on: August 24, 2016, 04:42:54 PM »

It is usually possible, if the springs have poor access, to push the keyboard carefull into place, then put in the screws.  You might be able to devise a way to clamp the keyboard into position, or get an assistant to help.

I'm very wary of doing this as I managed to really mess things up the first couple of times I replaced springs on my pokerwork.  The problem with leaving the spring tension there before screwing the tiny screws back in to the fondo, there's a high chance that the screws will rip out of the wood if it springs back ... and once that has happened it can be very hard to get the screws to stay in!  I ended up having to use some tiny long nuts and bolts to solve my mistake.

It is difficult to get the springs back in place after reassembly, but I've found the ideal tool in a very small crochet hook that can easily hold the spring without it slipping.

I bought a set of Dental Picks on Ebay for a few pounds only, they come with various shaped hooked ends,......very useful for manoeuvring springs and the like back into position,  I have even heard of them being used to lift reeds for tuning.
« Last Edit: August 24, 2016, 04:47:41 PM by Henry Piper »
Logged
From Ottery St Mary Devon. Currently Playing Dino Baffetti BP2 in D/G, Hohner Student 1 P.A conversion  in D/G,  Hohner 3515 Pre-Pokerwork in A/D,   2 row "Beaver Brand" in Bb/Eb, Hohner Pre- Erica in G/C .  Single row permanent 4 voice, 4 bass in C from old Hohner single row and bits of a cheap Cajun box !!,

Mike-T

  • Good talker
  • **
  • Offline Offline
  • Posts: 90
  • 1930s Hohner B C C#, D/GAcc Benny, 2.5 Beltuna
Re: Broken Spring
« Reply #25 on: August 24, 2016, 05:12:39 PM »

I found a long thin screwdriver with a small slot or V in the blade works quite well to unhook or replace springs.
Mike.
Logged

rees

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 5055
  • Windjammer
    • Wesson Accordions
Re: Broken Spring
« Reply #26 on: August 24, 2016, 06:49:21 PM »

I found a long thin screwdriver with a small slot or V in the blade works quite well to unhook or replace springs.
Mike.

I use that very same thing.
Logged
Rees Wesson (accordion builder and mechanic)
Gungrog, Welshpool, Wales, UK
www.melodeons.com

Theo

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 14475
  • Hohner Club Too
    • The Box Place
Re: Broken Spring
« Reply #27 on: August 24, 2016, 06:55:03 PM »

It is usually possible, if the springs have poor access, to push the keyboard carefull into place, then put in the screws.  You might be able to devise a way to clamp the keyboard into position, or get an assistant to help.

I'm very wary of doing this as I managed to really mess things up the first couple of times I replaced springs on my pokerwork.  The problem with leaving the spring tension there before screwing the tiny screws back in to the fondo, there's a high chance that the screws will rip out of the wood if it springs back ... and once that has happened it can be very hard to get the screws to stay in!  I ended up having to use some tiny long nuts and bolts to solve my mistake.

It is difficult to get the springs back in place after reassembly, but I've found the ideal tool in a very small crochet hook that can easily hold the spring without it slipping.

Yes quite right Squeezy.  I thought we were still discussing an older box with a wooden keyboard.  Having the-read the preceding posts I see it's a Hohner bass end that is being discussed, and yes releasing the springs is the only way to do it. With the right tool it is not hard to get the springs hooked up.
Logged
Theo Gibb - Gateshead UK

Proprietor of The Box Place for melodeon and concertina sales and service.
See my YouTube channel  for videos on repair and tuning

playandteach

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3526
  • Currently a music teacher in a high school.
Re: Broken Spring
« Reply #28 on: August 24, 2016, 07:45:47 PM »

I managed it easily and I am not brave at these things.
Logged
Serafini R2D2 GC, Serafini GC accs 18 bass

Pequod

  • Member
  • *
  • Offline Offline
  • Posts: 29
Re: Broken Spring
« Reply #29 on: August 25, 2016, 10:26:28 AM »

Ok, it's done. Thank you for your comments.

Actually I was replacing a spring on the treble end of a Pokerwork. I strongly advice everyone that after reassemble the springs and the axle back in place, to screw the treble mechanism first (4 screws), and only then hook the springs. After all, it's not difficult, I didn't had a crochet, but I did a small hook from a clip to lift the springs, and then with a plier pushed the spring up to it's place.

...
But after all it was not a 100% happy ending, cause after reassemble everything I noticed there's a note that's only sounding one voice... so I think I will need to reopen the box again... grrrr :o


Logged

Anahata

  • This mind intentionally left blank
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 6767
  • Oakwood D/G, C/F Club, 1-rows in C,D,G
    • Treewind Music
Re: Broken Spring
« Reply #30 on: August 25, 2016, 10:33:35 AM »

after reassemble everything I noticed there's a note that's only sounding one voice... so I think I will need to reopen the box again... grrrr :o

Yes, but you won't have to take the keyboard mechanism off again for that  :Ph
(just four bellows pins and whatever's holding the reed block in... much simpler)
Logged
Слава Україні !
Music recording and web hosting: www.treewind.co.uk
Mary Humphreys and Anahata: www.maryanahata.co.uk
Ceilidh band: www.barleycoteband.co.uk
Pages: 1 [2]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal