Sorry about the delay in replying...
Again let me repeat my expertise is in concertinas, the parallels to accordions are nothing like complete. And nor is my knowledge, ie. opinion alert!
Let me try an analogy; if you imagine the reed as a piston in a combustion engine, and imagine it is a sloppy fit. Some of the explosive force will leak around the piston and the engine will not be as efficient. Revheads say 'compression is acceleration', and this has to be true here too. The tighter the reed is at the most closed point the more force will be imparted to the reed by the airflow. The more force taken from the airflow the more open the reed will get, and more quickly also. So speed and volume are aided by tight clearances.
Tight clearances have other effects, ie. more higher partials, and its a lot more complex than this because as you can imagine there is more resistance on the return stroke also. Other factors are hardness of metal, thickness of reed, etc.
The role of the shape of the underside of the reed as it passes through the tightest point lies in creating that good seal. If the reed passes through the slot progressively with the tightest point travelling from root to tip then you are missing a percentage of potential thrust.
Predicting what shape will have a chance of travelling through the tight point all at the same time is difficult, its not going to be a straight line. The only reed for which this would be true would be one with a hinge at the root.
My experience is, long low reeds work well with a straight underside from the thinnest point. The longer the thinnest point is the more spread out that initial upwards curve needs to be. A reed which is wedge shaped ie. high reeds, will have progressively more lift along the reed proportional with the shape of the wedge.
I find when I am missing that last 1% in performance from a reed, attention to the exact shape of the lift will sometimes give it to me.
It is also the reason, while staring at the high reeds of my Castagnari, the ones inside the chamber, thinking how to lower their lift to get them starting a little easier, I can't see how to do it without removing them because though I could adjust them in situe it would be hard to assess their shape.
Hope this all makes sense, happy to hear contrary opinions...