Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: PZM mic - where to fit it in the bass end?  (Read 3537 times)

0 Members and 1 Guest are viewing this topic.

Clive Williams

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3936
    • Home Page
PZM mic - where to fit it in the bass end?
« on: October 01, 2008, 09:22:37 AM »

Alas, one of my AKG 416's has finally given up the ghost permanently, so I'm going to need to use a backup mic this Saturday coming. Fortunately... I happen to have an old Tandy PZM mic lying about (as you do), so assuming I can figure out where to put it, I should have a more than able replacement mic for the bass end. Lots of people have done this before I know, so where do you put them (on a Castagnari Mory) ? On the plate on the bottom of the bass end? On the side/front/back panel (assuming the bass buttons are on the 'front' panel).

I don't want to put a hole in the box (!), so would like to avoid mounting internally if I possibly could, though I guess if I had to I could run the cable out through the strap adjuster hole which has a little spare space on it. Is mounting it externally sensible at all?

Also what sort of EQ settings on the desk do people typically use with them being used as bass mics?

Thanks in advance,

Clive

j mobot

  • Member
  • *
  • Offline Offline
  • Posts: 11
  • Hohner Piccoletta Club I, Castagnari Dony
Re: PZM mic - where to fit it in the bass end?
« Reply #1 on: October 01, 2008, 01:34:40 PM »

Remove the two screws that hold the plate onto the finger-type-thing and mount it on the melodeon looking through one of the vents on the bass end. You could do it with velcro if you wanted to make it non-permanent.

You can see it in this picture - http://flickr.com/photos/75011423@N00/2618926001 - it's the black shape at the bottom of the box, with the cable going back in to an internal jack socket.
Logged

Clive Williams

  • Administrator
  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3936
    • Home Page
Re: PZM mic - where to fit it in the bass end?
« Reply #2 on: October 01, 2008, 01:49:09 PM »

Remove the two screws that hold the plate onto the finger-type-thing and mount it on the melodeon looking through one of the vents on the bass end. You could do it with velcro if you wanted to make it non-permanent.

You can see it in this picture - http://flickr.com/photos/75011423@N00/2618926001 - it's the black shape at the bottom of the box, with the cable going back in to an internal jack socket.

Ah lovely, thank you. Great picture by the way!

efsb

  • Guest
Re: PZM mic - where to fit it in the bass end?
« Reply #3 on: October 03, 2008, 09:07:36 PM »



Ah lovely, thank you. Great picture by the way!


Thank you..I'm the photographer.... :)
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal