You can save yourself a lot of fiddly work if at this stage:
- As the axle withdraws collect the arms and springs and keep them in order
you thread in a second piece of stiff wire to hold all the springs and levers in place.
If you do use Lester's method you should note that there are two different types of spring. The outside row springs are made of wire 0.55mm diameter, inside row 0.50mm. Make sure they go back on the correct row or you will fella differnt spring pressure between the rows. This applies to the new spring too, make sure it is the correct one for the row.
Just noticed that all this is duplicating what was said on the previous page of this thread.
