Same setup on my old Hohner 3 row. Check the base of the reed blocks with a straight-edge...if slightly bowed, level them. Lightly brush the nap of the gasket material with a soft child's toothbrush. The screws and bent nails are a good system if un-tampered-with. To remove/replace reed, gently twist nail 90 degrees, don't pull it out. If screws have not been abused, or stripped in the holes, they will work fine. Be sure to tighten them very carefully so they are just *snug*.
My old Hohner has the original nails, screws, and leathers (save one or two)that were originally on the treble side. I found that the leather was of superior quality, and was still quite pliable. I was able to remove all the reeds for cleaning and re-pitching to A440 with leathers intact, and using the home-made tool shown in the "Talking Reeds" website, was able to comb them back to relative flatness. I have played it steadily for 10 or so years, and no valve problems, and still great compression. I did replace the leathers on the basses, though...they were just to big to remain straight and provide a good seal. I used Italian leather with booster springs. I'm not a big fan of the plastic valves, although they seem to seal better, but I do not like the noise they make opening and closing, and sometimes they will even produce a vibration in sympathy with the reed which can be quite unpleasant. I hope your old Hohner gives as much enjoyment as I have had from mine!
