The steel pallet strapping is used for making general purpose flat thingies, used for pinging reeds, supporting reeds when filing, scraping wax and many other fettlings.
The GP flat thingies can also be made from empty baked beans etc., cans. Ensure your can is steel, not aluminium which is a bit too soft. If in doubt, test with a magnet!
Cut both ends off the can with a tin opener. Using tin-snips or even hefty kitchen scissors, cut the resulting cylinder vertically and flatten out into a sheet. Then, from the non-corrugated portions of the can, cut strips about 4 inches long by 1/2 inch wide. File off any sharp burrs along the strip edges. Flatten the strip as much as possible using a rolling pin. Finally, file down the 1/2 inch or so on each end face, thinning it to a shallow wedge and a fairly sharp edge on the tip.
You can cut several GP thingies from a single can, and make them different sizes and shapes (parallel-sided, tapered, etc.)