The pull E on the G row of my Giordy is slow to play and breathy. OK once it's going but annoying when trying to play quietly.
The reeds are flat mounted. Any thoughts on how to get at it to set it, or is flipping it the only option?
Even with flat-mounted reeds, you should be able to access the pull reed using a reed lifter to bring the tongue up through the slot. My preferred lifter is the Italian hook-shaped type, but the German flat pointy type should work too. Once you have the reed lifted, slide a cocktail stick* or wooden skewer* between the reed tongue and the reed plate and gently ease it upwards a few times. This should encourage a gap setting which is narrower than the previous setting.
Release the reed tongue and try out the reed response. Repeat if necessary. If you go too far and the reed chokes off, or has a weak sound, use the cocktail stick through the slot to push the reed tongue down to open up the gap a bit. Try out the response again.
Reiterate opening or closing the gap until the response is optimum. Then adjust the tuning as necessary.
As Lester has mentioned, the Giordy setting is particularly sensitive to small changes, but having worked on a couple of Giordys in the last few months, it is nevertheless possible to get the reed(s) performing properly without needing to remove the reed plate from the block.
*
Readily available improvised tools. However, for reed setting, I use a dentists' hand descaling tool (from Ebay/Amazon, etc) which is made of soft steel, softer than the reed tongue so won't scratch it, but less prone to sliding off than the wooden cocktail stick/skewer.