Recently purchased on ebay...but probably going back to the seller a HA114G "In perfect condition" (among other superlatives) and still in it's original box.
German made. Perfect apart from the minor detail that all the stops except the bass are stuck down -at least one appears to have rusted into the wood...the others may be stuck that way too.
OK- open her up....oh! the bellows pins are rusted in too. One comes out with extreme difficulty...if they are all like that I will almost certainly shear the head off at least one...
Test what I can. The Bass end Fundemental and chord's are good.. but there is a failed or failing reed in the melody chest.
On the positive side the bellows tapes are undamaged, though before I found the problem with the stops I had brushed a bit of mildew and the chrysalis of something out of the bellows folds.
Looks like it had spent some considerable time lurking , in it's box, in an unheated bedroom in rural Aberdeenshire.
So the question (while I decide whether or not to insist on a return to the seller).... if a bellows pin head does shear off is there a generally recognised way of getting it out without doing serious damage to the casework.
I might be inclined to try making a small drift from a panel pin with the point filed off and driving the pin right through into the bellows. That may work if the pin is already through to the inside of the bellows- but a rust bound pin being driven through whitewood may well rip some big splinters out en-route. Risk of smashing the case work? or are melodeons tougher than that?
Alternatively...
Answers on a post card...