I've been planning to do some work on my boxes for quite some time, but Lester's
Hot Rod your Hohner and the recent arrival of needed materials prompted me to actually roll up my sleeves and get to it.
I'm going to try and in this thread what happens to mortals with some mechanical sense who attempt to follow Lester's series.
(
my first post was in Lester's thread but I'm moving my discussion here so people who see new posts there aren't disappointed that it's me and not a new episode)
The box in question is a Hohner Club IIB Victoria, which is a bit different from the Pokerwork, but I think many things are transferable.
I suspect this box has been fettled in the past for two main reasons:
1) There were two types of pallet facing: The pallets of the two main treble rows had 1-layer facing while the bass and the short row had green felt+leather facing. Moreover, the bass pallets were held by very weak glue while the treble pallets had a strong one (see
my previous post).
2) The bellows are in a surprisingly good shape and have a diamond shape on them which AFAIK isn't a standard Hohner thing.
Refacing the palletsOther than the need for a soldering iron, removing the pallets on both sides was ok. A file and some mildly aggressive scalpel use managed to clean the levers from the glue.
Putting the pallets in their place was mostly straightforward, holding the soundboard in front of a light to see if there are leaks was very useful.
The Good:
I've managed to get it more airtight than it was before I started, the buttons are more level, there's far less pallet noise and it's a joy to play.
The Bad:
Gluing the pallets back was easy for most of them, but the half-row are hidden behind the levers of the other rows, so I tried to drip some glue from above. This resulted in a terrible mess of pallets glued to the soundboard and to each other which took some time to clean.
All in all it's not my prettiest job ever, but It does the job and it's mostly reversible.

With the gained experience, the bass side looks much better I think.

The Ugly:
If you look carefully at the picture of the bass mechanism, there are only 7 rods

It appears the the little pins in the pokerwork are not the only thing that can split and one of the rods decided to fail when I've attempted to reinstate it

Which brings me to the current state where I have a 7-bass box to fix. I suspect I'm not the first person it happened to. Any suggestions? (using what I have or can get in a nearby store if possible)
Note that there's not enough length in the rod to both be effective and go through the mechanism, I've tried.