I'm working on a one-row, 4-stop accordion in the key of G. When tuning, I use the instrument's own bellows, holding the end frame against the instrument while I check the note in question against my tuner (and ear). This practice has always worked well for me, however I noticed that on this instrument, the pitch of the lower notes changes noticeably from when I test it as described above, to when checking them again once the end frames have been screwed back together. At this time I find that the pitch of the lower notes is a bit flat. Disassembling the instrument once again to re-check I find that everything is perfectly in tune (the pitch of the reeds are as I had tuned them), but once again those notes are flat when the instrument's end frames are screwed together. I can only assume that, despite my holding the ends together when testing, that there is some air loss which is affecting the pitch of those reeds. This only happens with the lower notes, as about halfway up the keyboard everything else stays the same.
This has necessitated me having to tune those reeds a little sharp in order for the pitch to be correct spot once reassembled. This is a bit of a pain because reassembling the instrument involves four long screws, and obviously going back and forth is laborious and tedious. I don't suppose there's another work-around? Has anyone else come across this when tuning cajun-style boxes? The Hohner HA114s, and any one-rows that use bellows pins do not seem to have this problem.