After manufacturing and fitting a 3rds removal stop to my old and little used Hohner Club Modell 2 C/F, I decided to clean up the reeds, re-valve them, and convert the block from wax to screw fixing, using gaskets laser cut from Olivisc.
The problem of course, is that the aperture on the block extends right down to the base plate and is normally filled with wax. A gasket requires a solid seat, so rather than cut endless little bits of wood and gluing them in, or cram the reed plate down onto a 90 degree strip if gasket, I adopted a different approach.
Firstly, I sanded the two faces of the block, taking off 1mm or so. I then, from 1mm aircraft ply, made two facings, one for each side, which include the bottom bit missing from the block, (see the pictures). Empirical experiment showed me that there is enough room left for the reed and valve to function with the aperture effectively reduced in size. Having glued on the facings and sanded down to neaten and clean everything, I gave it all a coat of Danish oil. This does not, as some will venture, compromise the gaskets adhesion, but rather having dried, it allows just the necessary level of adhesion, allowing pulling off and re-positioning if needed.
Finally, put all the screws in ready for the cleaned reeds. Job done! I may even play it some time.
Has anyone else used this method? Did it work OK? Any comments or suggestions for a better way?