Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: Brass reeds  (Read 736 times)

0 Members and 1 Guest are viewing this topic.

John MacKenzie (Cugiok)

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 2360
  • Fettling... Learning to reed and right.
Brass reeds
« on: August 18, 2020, 10:16:10 PM »

I have a concertina which I have been asked to see if I can repair it. It has multiple brass reeds on a single plate, and one is snapped off. Is it possible to replace  such a reed?

Sir John
Logged
There is no beginning to my talent :)



: Hohner Club Modell 1. Bb/Eb, de-clubbed : Early Hohner Pressed Wood A/D : 1930's Varnished wood G/C:  Hohner Erika C/F: Bandoneon tuned D/G Pressed wood: Koch F/Bb; G/C Pre Corso

Elliot Warburton

  • Member
  • *
  • Offline Offline
  • Posts: 34
Re: Brass reeds
« Reply #1 on: August 18, 2020, 10:52:13 PM »

I've done it, it's not too much trouble. Take a dremel (shock! horror!) and v v v carefully take off the top of the rivet on both sides of the broken reed. Then get a punch of appropriate size and knock out the old rivet. To make this easier, seat the reedplate on a bit of plastic or something with a hole in it the size of the rivet, so you can easily punch it through and into the hole. Make the new reed with appropriately thick (I would start a little thicker and the file/carefully sand/grind to the correct thickness) brass sheet stock, which is readily on e-bay. Scribe the reed onto a strip, cut it out roughly with tin-snips (for example), flatten it, file to the line, test fit, file etc and then rivet in place. I made the new rivets using segments of a nail i found lying around that was the right diameter. Then just refine the fit and tune. Sounds tricky but it's not once you've got it together for it. If you mess up too much it's not a problem to just de-rivet it like before and try again.
Logged

Pearse Rossa

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 723
Re: Brass reeds
« Reply #2 on: August 19, 2020, 12:36:16 AM »

These videos refer to harmonica reed plates, but you might find them useful.

https://www.youtube.com/watch?v=-fVReyQfwA8
https://www.youtube.com/watch?v=dnXJBXyQYhY
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal