Melodeon.net Forums

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to the new melodeon.net forum

Pages: [1]   Go Down

Author Topic: New Paolo Soprani Jubilee IV bellows removal?  (Read 1163 times)

0 Members and 1 Guest are viewing this topic.

Don Howell

  • Member
  • *
  • Offline Offline
  • Posts: 10
New Paolo Soprani Jubilee IV bellows removal?
« on: October 17, 2020, 10:16:01 PM »

Maybe someone can help me with a technical issue? I just received my new Paolo Soprani Jubilee IV shipped by Massimo Mazzantini at Castelfidardo Musica in Italy. This is my very first Paolo Soprani, and when playing it, I noticed the Middle G bassoon reed on the 4-voice setting sounds out of tune. All the other notes sound fine, both on 4-voice and 3-voice settings. Quite aggravating considering I play quite a few tunes in G using the 4-voice setting, so that bassoon G note is used all the time. Hopefully, it just needs a break-in period. I wanted to take a look at the treble reeds, so I took out the 6 bellow pins to open up the accordion. The bellows won't separate from the frame. I am uncertain if the bellows are also glued to the accordion frame on the new Paolo Soprani’s. I sure do not want to cause damage to the bellows if they are indeed also glued in. Any thoughts?
Logged

playandteach

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3526
  • Currently a music teacher in a high school.
Re: New Paolo Soprani Jubilee IV bellows removal?
« Reply #1 on: October 17, 2020, 10:19:18 PM »

Is that 6 bellows pins on one end? If so you could take off the other end. If it's 6 for both ends, then are you sure you haven't missed one? I can't think of a reason both ends would be glued - or for that matter have glue and pins. My Serafini is glued at the bass end, but obviously no pins on that end. I also can't see how a reed would break in to being in tune. Good luck.
Logged
Serafini R2D2 GC, Serafini GC accs 18 bass

Don Howell

  • Member
  • *
  • Offline Offline
  • Posts: 10
Re: New Paolo Soprani Jubilee IV bellows removal?
« Reply #2 on: October 17, 2020, 10:24:01 PM »

Yes, there are 6 pins on both the treble side and the bass side. I removed all six on the treble side.
Logged

JNM SY

  • Regular debater
  • ***
  • Offline Offline
  • Posts: 227
Re: New Paolo Soprani Jubilee IV bellows removal?
« Reply #3 on: October 18, 2020, 03:48:59 AM »

Sometimes the screws that hold the bellows straps on can go right through the case and into the bellows frame , locking it shut. Try unscrewing them half way out.
            Good luck,     John
Logged

Steve_freereeder

  • Content Manager
  • Hero Member
  • ***
  • Offline Offline
  • Posts: 7511
  • MAD is inevitable. Keep Calm and Carry On
    • Lizzie Dripping
Re: New Paolo Soprani Jubilee IV bellows removal?
« Reply #4 on: October 18, 2020, 06:25:00 AM »

...I also can't see how a reed would break in to being in tune.
It's possible; it depends on how much and in which direction (i.e. sharp or flat) the reed is out of tune.

The reeds on new instruments, or newly tuned instruments, do settle down after a short time to achieve a stable pitch. Usually it's just a few hours but it can be longer. I think it is to do with the stresses in the steel gradually equalising as a result of the vibration cycles. Thats why, after doing any reed work, it's always worthwhile playing the instrument a bit, then letting it settle for a day or so, then checking again and adjusting if needed. Once settled or 'played in' if you like, reeds tend to go a bit flat with time (months/years) depending on how hard they are played.

There are other factors which can affect and vary the pitch of reeds on new instruments:
Sometimes the valves need to settle down too. A newly attached, or slightly stiff valve might not open quite as far as a valve which has been in place for some time, which in turn can affect the pitch. A reed which has been tuned to be at pitch with a new valve can theoretically go a bit sharp if the valve then gradually becomes more pliable and opens slightly more.

Another instance I've noticed is the the change due to freshly applied reed wax gradually hardening off over a course of a few weeks. This can change the rigidity of the reed plate and reed block coupling, which again can cause small changes in pitch and/or timbre, usually barely noticable, but it does occur. People usually report something to the effect that after a few weeks or months of playing, their instrument sounds brighter and really begins to 'sing' nicely.
Logged
Steve
Sheffield, UK.
www.lizziedripping.org.uk

playandteach

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 3526
  • Currently a music teacher in a high school.
Re: New Paolo Soprani Jubilee IV bellows removal?
« Reply #5 on: October 18, 2020, 09:35:16 AM »

The only other thing I can think of is that a stop goes through the bellows. That's true on my Sander. I have to remember to unscrew the rod before prising off the bellows.
Logged
Serafini R2D2 GC, Serafini GC accs 18 bass

Don Howell

  • Member
  • *
  • Offline Offline
  • Posts: 10
Re: New Paolo Soprani Jubilee IV bellows removal?
« Reply #6 on: October 18, 2020, 01:05:50 PM »

Thanks all. I discovered that the bellow strap bracket's mounting screws on the top and bottom of the accordion were the issue with not being able to remove the bellow frames/bellows from the accordion body. The tips of the two mounting screws on both top and bottom were recessed into the bellows frame. This is why the bellows frame could not be removed. Upon inspecting the middle G bassoon reed and valve, both looked fine. Hoping the reed will "settle in."
Logged
Pages: [1]   Go Up
 


Melodeon.net - (c) Theo Gibb; Clive Williams 2010. The access and use of this website and forum featuring these terms and conditions constitutes your acceptance of these terms and conditions.
SimplePortal 2.3.5 © 2008-2012, SimplePortal