I have just done the Lester Hot-rod work on a Hohner/Koch G/C and, having developed a taste for servo screws, opted to use them for the reeds rather than wax. Olovisc on the blocks, 2.2 x 11mm hex-drive Servo screws, from a R/C Model outlet on-line, 2mm drill & 2mm Hex drive insert in a magnetic holder.
I re-tuned using Steve_Freerider's tuning guide to his Mory 'standard'. The use of the 'dry' fitting allowed for a very fine tuning by virtue of thumb pressure fitting/re-fitting until the fettling was done as opposed to having to do finishing work on the reeds after waxing, which I always find a messy job.
The Servo screws have a built in washer head which works well to nip the reed to the gasket. Learning from the 1930's Boxes I have just worked on to de-club/tune, I fitted a small trim to the base of the blocks and lined it with a strip of quality leather to seal the bottom edge of the reed plate.
I think I am a convert.