If you could file fast enough, you could possibly get some sparks going!
When I was building my bass instrument, I needed some reeds (on more or less normal sized plates) to go pretty low. I used some PA bass reeds, and after looking at some others, it was plainly obvious that they had been ground down using a rotary stone of some description.
In for a penny and in for a pound! I took a few down a long way, without having to overload them with solder, by carefully and neatly grinding away the lower portion of the reed tongue to about half it's thickness for about a third of its length. I had noticed a good number of original reeds which were done that way.
I've also seen a great number of original treble end reeds with rotary stone markings on them, when I've been using a file or a scratcher.