Hi,
I'd like to adjust the keyboard so that the keys all sit level when at rest (on or two are a little out of line) and also regularise the amount of travel. I've had a good look at the mechanism and I'm turning over few ideas but I thought I'd have a trawl on the forum to see what people think. Especially before I start doing something that might not be easily reversible.
As far as I can determine the buttons are made up from a truncated cone that looks like cork (sort of bucket shaped), with a mother-of-pearl effect button on top, and a felt pad on the bottom of the cone. The felt pad limits the downward travel, and since some buttons go down further than others I guess that means that those felt pads are differing thicknesses. The bottom of the keyboard has a strip of some sort of hard felt, or maybe its suede, under the buttons.
As far as I can see there are two options to set the travel (1) Pack under the the buttons individually to get them each to the desired travel, or (2) Trim down the existing felt until they all travel the same distance, even though that will be too far, then add another layer of something under the keyboard as a limit.
Any comment on either of these two options? The reason for wanting to reduce the travel is to reduce the times that the keys rub or click against other parts inside the keyboard, that was getting on my nerves.
Thanks in advance,