Hi all, I was trying to find info on limiting button travel on the old Hohner one-row but couldn’t find what was looking for, so I came up with my own solution that I thought I’d share…
I cut ten 15mm lengths of 6mm square dowel, which I then lined up on a strip of double sided tape before cutting out neatly with a craft knife. Having taken the backing from the tape, I carefully placed each length of dowel under its lever using some tweezers and a steady hand!.. I then pushed the button down to securely position the piece of wood in place. With still a little too much travel in the buttons, I finally wedged little strips of felt between the lever and dowel and this finished the job off nicely. I haven’t attempted to take the keyboard off yet, so not sure if this is possible without removing the wood strips, but anyway not too permanent since I used double sided tape!..
I also found a nice thin wine cork and used this to limit the left hand spoons (I call these bits of cork spring-savers since I’m assuming this will reduce the likelihood of spring breakage!?..), although that’s an idea I had seen before elsewhere…