I'm retuning a Honher Club modell VIII from C/F to D/G. Retuning the treble side has gone reasonably smoothly. I'm a beginner when playing it, but my local melodeon experts tell me the sound is good. (Although I'm leaving the accidentals till later...).
But I've hit a problem with the bass side.
It has eight buttons (four bass and four chord), and I believe the chord and bass buttons in D/G need to be C/C, G/D, B/E and D/A.
Chords have three notes, so for four chord pairs that's 12 pairs of reeds.
But the box only has the mechanics for ten reed pairs!Hohner seemed to get round this in the original C/F tuning by using some of the reed pairs for more than one chord. I don't see how to do that in D/G. I'm told it can be done; but how?
More information about what I've done so far, following what I found when tuned to C/F, in case there's an answer there...
The bass notes all play FOUR octaves, for example C plays C2, C3, C4 and C5. A broad range, but I believe that's as it should be.
The reeds for C4 and C5 are on opposite sides of the wooden reed-holder but are activated by a single pad. The same pad also opens when playing the C chord.
In fact all the chord buttons play their three notes at two octaves. So the C chord plays C4 and C5, E4 and E5, G4 and G5. But that's done using one pad for each octave pair, so I see no scope for freeing anything up there.
I can see that chords C and D are replicated by different buttons, so I thought there might be an answer there. But the push and pull reeds for a single button have to be on each side of the same reed plate. So, if I was trying to avoid duplication of the D chord, the pairs on one plate can't be both (D and A) and (G and D) at the same time.
Help! I'm thinking maybe I will have to sacrifice one of the less used chord buttons - maybe B+E-. But I'd rather not.
Many thanks in anticipation...
Peter
