Is that a metal fingerboard on your pokerwork? Nice
Lovely version as well, I think I prefer it to the standard one.
Its a wooden finger board with aluminium finger plate (work in progress).
Cool. How have you done it?
I didn't do anything too fancy, just marked the holes which from memory are spaced 17mm between the rows, and 20mm along the rows. I used a stepped hole cutter and drilled them to 14mm. The buttons on my box are a bit "all over the place" and some of the holes needed to be opened out a little to clear the front or back of the key in its travel. If you have access to a mill or something fancy, you'd maybe do the holes as 13mm wide by say 15.
I used 1.5mm plate, but if I did it again I'd use 2mm or maybe even thicker, the limit being that the bottom of the button needs to be below the bottom of the plate, otherwise it catches on any felt bushing.
Maybe this should be moved to a new thread in "Construction"?