Thank You, Martyn! One more question, is it possible to replace the bass buttons on a Hohner Picoletta with new Hohner mushroom style buttons? How can I remove the old buttons and install the new ones?
It can be a bit tricky removing the old bass buttons as they can become quite brittle.
If I was doing it I would remove the rods that the buttons are attached to by taking out the small pins that connect them to the levers. Then put the rods in a vice and pull the buttons off by hand, sometimes applying heat to the rod will help a bit. A soldering iron works well.
The replacement buttons can then be fitted, these will be easier to fit if the end of the rod is heated first. Now is also a good time to replace the felt washers.
If the pins have been removed carefully these can be re-used, or a veneer pin of a suitable diameter can be cut to length.
I would only replace the bass buttons if they were broken and then use a matching old one rather than using new.
Hope this is of some help.
Martyn
www.melodeonrepairs.co.uk