Theo and others, I was looking for some instructions on button tension softening, and found this comment on a Cajun site:
".............To loosen springs is easy. I once watched an old Cajun accordion builder take a 12 inch stainless steel ruler, place it's edge into all of the button springs at once, and bend downward in one quick and sure motion which stretched every spring to the exact same tension in about 3 seconds. Smart ole feller. "
Could I please have some comments on whether that would be something to try on my Sander? Any thoughts about it at all.
I spoke to an accordion repairer a couple of states away from me, and he said he would have a go at the springs/button softening, but that he had not done it before.
If I am going to get someone to do it for me, I was hoping they would have done it before, but in case that cannot be, then some clear easy instructions for me to give to someone would be appreciated.
I did see the instructions earlier posted by Syale, however if the 'ruler' method is feasible, that might be something I could present to a first time repairer, or even attempt myself.
Thank you